Motorcycle Safety circuit with Touch Sensor felt too sensitive, so the circuit often became active without being touched. Modifications to the circuit to reduce its sensitifity is by dispose the D2 and the R4 and use only R2 only.
Motorcycle safeguard with a combination of turn signal switch. A motorcycle can only be switched on after the turn signal are lit with a particular combination. If the combination is correct, then the bike could be turned on, if the combination is wrong, motorcycles cannot be turned on.
After making alarm addition of the touch sensor circuit of motor security, many readers ask me to add the locking mechanisms to this alarm. Thus, if the alarm has been activated, the alarm will keep activated even though the motor’s key is turned off. The addition of a locking mechanism like this actually is very […]
Adding an Alarm Touch sensor as a motorcycle security is already quite sacure. However, adding an alarm is a plus for securing your motorcycle. If the motorcycle’s lock is rotated to the ON position, then if in about 6 seconds, the touch sensor is not touched yet, the alarm will be activated. For those of […]
At the Motorcycle Safeguard with Touch Censor, we’ve created a mechanism to make relay on if the sensor is touched and remained active even though the hand had been released from the sensor. With only one sensor the security of motorcycle is pretty good. However, sometimes people like to overdo in acting. Therefore, some people […]
How to secure a motorcycle? Security motorcycle is basically making a double switch in addition to the lock switch on the motorcycle. Motorcycle can be turned on only if both the original and additional switch are ON. Additional switch is usually placed on a hidden place. Usually under the seat. Although this methode is very […]